How To Perm Hair: Winding and Sectioning System

Just before you start out winding the hair, you want to individual the hair into workable sections. This will make the hair simpler to handle and appears to be expert. Sectioning the hair tends to make the relaxation of the perming procedure less complicated and quicker. Immediately after shampooing and towel drying the client’s hair, comb the hair to eliminate any knots or tangles. Assure you have all the perming applications handy.

There are 3 various sectioning styles.

1. Six Segment

2. Brick

3. Directional

6 Part

The 6 Sectioning pattern divides the head into six sections Divide the hair into two sections, front (4,6,5) and back (3,1,2). Divide the entrance segment just earlier mentioned the middle of the eyebrow, to give a center (6) and two sides (4 and 5).

The middle segment (6) really should not be any broader than the curler. Now divide the again area the same, to give a middle (1) and two sides (3 and 2).

Brick Winding

Brick winding is when the perm curlers are positioned in a brickwork sample. This winding approach prevents any gaps in the hair, so you will not have any partings. Brick winding is ideal for brief fantastic hair and really should be started out at the entrance of the head.

Directional

Directional winding is when the hair is wound in a selected direction. It will support create a flow in the course the client needs. It is great for clientele who want a parting.

Winding Strategy

Right after positioning the hair into the required sectioning you will will need to wind the hair.

·Hair ought to be kept damp.

·Take a tiny sub-section of hair, lesser duration and thickness of a roller.

·The width of the segment must be inside of the width of the curler.

·Comb the hair upwards, this will lead to root lift.

·Hold hair evenly and limited.

·The curler must be at 90 degrees angle from the head shape.

·Put an end paper on the finishes of the hair if you never the ends will glimpse frizzy at the finish of the perm.

·The finish paper aids make the winding procedure a lot easier.

·Wind the hair down slowly, holding the hair evenly limited.

·Guide the hair finishes spherical the roller with tail comb. If the ends do not go beneath the roller. The hair can turn out to be “fish-hooked” and frizzy.

·Keep the curler degree.

·The curler really should be in the centre of the sub-part.

·Secure the curler by fastening the rubber bond or clip.

·The curler need to sit on it’s base and not impede the next curler’s positioning.

·There should really be no gaps between the curlers.

·If making use of a band rubber, be very careful of positioning it to close to the root spot, as this can trigger a rubber mark on the hair.